MIL-STD-962-SUP-1 Defense Standards Format and ContentThis standard establishes the format and content requirements for the preparation of standards prepared either by DoD activities or by contractors for the DoD.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18 - 19 - 20 - 21 - 22 - 23 - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39 - 40 - 41 - 42 - 43 - 44 - 45 - 46 - 47 - 48 - 49 - 50 - 51 - 52 - 53 - 54 - 55 - 56 - 57 - 58 - 59 - 60 - 61 - 62 - 63 - 64 - 65 - 66 - 67 - 68 - 69 - 70 - 71 - 72 - 73 - 74 - 75 - 76 - 77 - 78 - 79 - 80

MIL-STD-962D

w/CHANGE 1

MIL-STD-123B

w/CHANGE 2

FOREWORD

1.  This standard is approved for use by all Departments and Agencies of the Department of Defense (DoD).

2.  This standard covers the procedures for ultrasonic inspection of bar stock selected for the manufacture of bearing balls used in armored vehicles.

3.  Comments, suggestions, or questions on this document should be addressed to Commander, U.S. Army Tank-Automotive and Armaments Command, ATTN: ABCDEFG, Warren, MI  48397-5000 or emailed to tacom@army.mil.  Since contact information can change, you may want to verify the currency of this address information using the ASSIST Online database at https://assist.daps.dla.mil.

ii

FIGURE 7.  Example of change to standard - Continued.

48