MIL-STD-962D
requires the use of any toxic chemicals, hazardous substances, or ozone-depleting chemicals, these should be included in the key word listing. The subject terms shall not repeat words found in the title of the document. The subject terms are to be listed alphabetically in a single column with the main noun or word first, followed by sequential modifiers separated by commas. Word groups that are considered to be proper or recognized nouns, such as "printed circuit board," should not be separated. The number of subject terms listed shall not exceed 25.
5.12.10 International standardization agreements. If the standard implements an international standardization agreement, the following statement shall be included in section 6:
"6.X International standardization agreement implementation. This standard implements (insert the document number and title of the international standardization agreement(s)). When changes to, revision, or cancellation of this standard are proposed, the preparing activity must coordinate the action with the U.S. National Point of Contact for the international standardization agreement, as identified in the ASSIST database at www.dodssp.daps.mil."
5.12.11 Identification of changes from previous issue. Revisions of standards shall include vertical lines, asterisks, or other markings at the margins of the pages to indicate where changes have been made with respect to the previous issue. The note below shall be included as the last paragraph in section 6 of the standard. The words "vertical lines" may be replaced with whatever marking is used to denote changes.
"6.X Changes from previous issue. The margins of this standard are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue."
If the changes are extensive and too numerous to annotate, the following note shall be included in section 6 of the standard, but every effort should be made to annotate the changes:
"6.X Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extent of the changes."
5.13 Concluding material. The concluding material shall be provided at the end of the document following any tables, figures, appendixes, or indexes. The concluding material shall indicate the preparing activity, custodians, review activities, civil agency interest, industry association interest, and project number, as applicable (see 5.13.1 through 5.13.8). The following is an example of the concluding material format:
"Custodians: Preparing activity: Army - AR Navy - SH
Navy - SH (Project 9110-1234) Air Force - 11
26
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business