MIL-STD-962D
index. Government specifications, standards, and handbooks shall be listed numerically (except federal specifications, which shall be listed alphanumerically) under the following headings in the order shown, as appropriate:
INTERNATIONAL STANDARDIZATION AGREEMENTS FEDERAL SPECIFICATIONS
FEDERAL STANDARDS
FEDERAL INFORMATION PROCESSING STANDARDS COMMERCIAL ITEM DESCRIPTIONS
DEPARTMENT OF DEFENSE SPECIFICATIONS DEPARTMENT OF DEFENSE STANDARDS DEPARTMENT OF DEFENSE HANDBOOKS
5.8.2.1.1 Standards shall include the following paragraph as 2.2.1 if specifications, standards, and handbooks are to be listed as applicable documents:
"2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and handbooks form a part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or contract."
5.8.2.1.2 The parenthetical source statement below shall follow the listing of Govern- ment specifications, standards, and handbooks. The ASSIST database shall be checked to verify that all of the listed Government specifications, standards, and handbooks are in the ASSIST database. If they are not, contact the DoD Single Stock Point to determine if the missing documents can be included in ASSIST and what action must be taken. If the documents are not in the ASSIST database and they cannot be included in the database, the source for obtaining these documents shall be included.
"(Copies of these documents are available online at https://assist.daps.dla.mil/quicksearch/ or www.dodssp.daps.mil or from the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)"
5.8.2.2 Other Government documents, drawings, and publications. The following types of documents shall be listed after the paragraph of 2.2.1 above, in appropriate order (numerically or alphanumerically), under the headings of the issuing Government agency. The document(s) shall be listed by identifier and title, if applicable. Titles shall be taken from the document rather than from an index.
a. Other types of DoD publications, which might include technical manuals, design guides, cataloging handbooks, or reports.
b. Drawings. When detailed drawings referred to in a standard are listed in an assembly drawing, it is only necessary to list the assembly drawing. Figures bound integrally with the standard are not considered drawings and shall not be listed in section 2, unless they are
reduced-size copies of drawings provided in the standard for information only and use of the full-size drawings is normally required with the standard.
21
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business